Hey, i’m the circle brush size cursor issue anon: So cursor anon has sent me a submission but I cannot send it for some tumblr-known reason, so: If anyone has seen this happen also and can give a better guess to what might be causing it, you can reply to this post.
You might be better off sending in a bugreport to the FA development team through the official site. Something like this to me seems more like a hardware/monitor issue but I could be wrong. I’m not sure what part of the brush resize action you mean, I think I’ve seen it happen a few times before as well but I cannot replicate it. The circle part of the brush size cursor does this copy and freeze a piece of the circle when the brush size goes larger every time I move the brush cursor. There is this annoying thing that the firealpaca brush size cursor does to me.
If you need to save your selection, make a new layer and fill it with black. * If you accidentally deselect while making your selection better, you can undo the deselection. I would reccommend using a hard-edged brush to get a clean look for your transparent area and avoid problems when viewing the work. Press Z for temporary transparency while drawing or Shift+Z to switch your brush to transparent. You can also use the transparent brush feature in Firealpaca while in the Select Brush.
This works pest with a brush that is close to what you want the edges to look like. Select the tool and then select the kind of brush you would like to edit with. Works basically the same way as a regular pen, but you instead draw and erase selections. These two are under the other selection tools. * what you can also do is that if the selections are not fine enough for you, use the Select Pen and Eraser Pen to refine the edges of these selections.
#Hair brush firealpaca plus
Your select tool cursor will have a little plus under it to indicate this. You can also use the Magic Wand first, then the other selection tools, but what helps is pressing Shift to add to the selection. * the magic pen is usually not a good tool for this, especially if this area is a traditional drawing scan (lots of different-colored pixels, so even with the tolerance higher, hard to get an exact area) so what I usually do is use the Lasso tool or even the Select tool (Polygon), to get a general area. So I assume you mean that you want to just cut out parts of a picture and make it transparent. * you’re trying to crop things out - usually cropping means cutting off an excess part, but in digital graphics this more exact - an image can be cropped to exclude some frame or outer parts, but not the inside of it. Hi! Ok, so I want to clear some things up before I properly answer: Am I doing something wrong or is there a better way to do this maybe? I've tried messing with the tolerance but haven't had any real success. And I always try the magic pen tool to just select what I want to and then just delete everything else but it never really works and I always end up just going in and erasing stuff manually. Sometime I'll be in Firealpaca trying to just crop the white space or shadows out of a picture so I can make it transparent.
0 kommentar(er)
